Laser marking machine operating procedures

Laser marking machine operating procedures

Many friends do not know what the operation process of laser marking machine is. Below, Shanghai Yuehua Laser Technology Co., Ltd. will briefly describe the standard process of laser marking machine for you.

1. Start up. The steps to turn on the laser marking machine are as follows:

a. Check the power cord of the marking machine to make it connected correctly and reliably;

b. Insert the key switch, rotate 90o clockwise to the "on" position, and turn on the main power. The power indicator is on;

c. Confirm that the laser head mushroom button (emergency stop switch) is in the pressed state;

d. Turn on the computer monitor and the power switch of the computer host;

e. Rotate the red mushroom button in the direction of the arrow to make it pop up, and then the laser head can be powered on. After about 1 minute, the laser head starts to complete;

f. Remove the lens cover; At this point, the laser marking machine is turned on, and the marking operation can be carried out by the operator's command.

2. Marking operation

a. Double-click the marking program icon to enter the program;

b. Select the marking file, double-click the date and time in the content to modify, and click OK to complete the modification;

c Marking test and printing position

d. On the workbench or production line, place a test piece with the same height as the marking workpiece (it is better to choose the marked workpiece as the test piece), and confirm that the test piece is indeed stable;

3. Mark by operating the marking control software. For the best marking effect, the following steps can be adjusted:

a. Adjust the focal length by adjusting the light head lifting device;

b. . Adjust parameters such as power and marking speed in the marking software;

c. Enter the software, double-click the print date, drag the mouse up and down, and adjust the print position to the appropriate position. 

4. After completing the above steps, the printing test can be performed.

5. After the test is correct, you can re-mark on the workpiece. 

6. Shutdown After the production task is completed, the operation steps for shutting down the laser marking machine are as follows:

a. Press the red mushroom button (emergency stop switch) to cut off the power of the laser head;

b. After confirming that the industrial computer is not running any software, exit and shut down normally;

c. Rotate the key switch 90o counterclockwise to the "off" position, turn off the main power of the marking machine, and the power indicator light is off;

d. Unplug the key and have someone keep it for the next use;

e. Cover the lens cap.