Daily maintenance method of laser cutting machine

Daily maintenance method of laser cutting machine

Any machine must pay attention to maintenance during use. The stability and normal operation of the machine are inseparable from daily maintenance.The correct maintenance method can not only improve the working efficiency of the laser cutting machine, but also prolong the service life of the laser machine, which can better save production costs and win greater benefits.

Regarding how to maintain the laser cutting machine, Yuehua Laser has organized the following relevant knowledge for you, hoping to help you.

1. Change the water and clean the water tank (it is recommended to clean the water tank and replace the circulating water once a week)

Note: The laser tube must be filled with circulating water before the machine works.

The quality and temperature of the circulating water directly affect the service life of the laser tube. It is recommended to use pure water, and the water temperature should be controlled below 35°C. Replace the circulating water above 35°C, or add ice to reduce the water temperature, and add water (cooler, it is recommended that users choose or use a second water tank).

Cleaning the water tank: First turn off the power, remove the water inlet pipe, let the laser tube automatically enter the water tank, open the water tank, and pump water to remove the dirt on the water pump. After cleaning, clean the water tank, replace the circulating water, return the water pump to the water tank, insert the connecting pipe into the water inlet of the water pump, and arrange the joints. Run for 2 to 3 minutes using pump power alone (laser tube filled with circulating water).

2. Cleanliness of the fan

After long-term use, a large amount of solid dust will accumulate inside the fan, making the fan make a lot of noise, which is not conducive to exhausting except for the smell. When the smoke of the fan with insufficient suction is not smooth, turn off the power first, discharge the fan into the air duct and air duct, remove the dust inside, and then install the fan and pull out the air duct inside. Blades until clean, then put the fan installed. Then it can support the co2 laser machine to work normally.

3. Lens cleaning

The lens is easily contacted by dust or other contaminants, causing the laser lens to be lost or damaged. It does not have to be removed. When cleaning the lens, you need to dip it in cleaning solution to clean the lens paper, and carefully wipe along the edge of the center of the lens in the direction of rotation. The lens and focusing lens are wiped from the frame in the same way, and then reattached in the same way after the wipe is complete.

Matters needing attention: (1) The lens should be wiped gently without damaging the surface coating;

                                            (2) It should be removed and wiped gently to prevent falling;

                                            (3) Make sure to keep the concave side down when attaching the focus lens.

Regarding how to maintain the laser cutting machine, the above is some relevant knowledge organized by Yuehua Laser for you. If you have any other questions about the laser machine, you can leave us a message.